PRODUCT INFORMATION
Product Overview
The General Electric DS200SDCIG1ABA is a Mark V Power Supply board. It serves as an interface to DC2000 drives within Mark V systems. The unit provides power and instrumentation functions for automated drive assemblies. These assemblies operate in wind, steam, and gas turbine installations. The board includes normal protective coating across its components.
The circuit board integrates standard voltage-limiting hardware components. These components include rectifiers, diodes, capacitors, and integrated circuits. The board incorporates several dedicated fuses for circuit protection. It also features jumpers for configuration of drive control signals. Onboard LED indicators identify blown fuses during system operation.
TECHNICAL DATA
Technical Specifications
| Parameter | Specification |
|---|
| Instruction Manual | GEI-100173 |
|---|
| PCB Coating | Normal Coating |
|---|
TECHNICAL INFORMATION
Features
- Interfaces directly with DC2000 drives in Mark V turbine systems.
- Features normal protective coating over base board hardware components.
- Includes FU1 115 V AC power fuse protection.
- Includes FU2 and FU3 DC signal-level power supply fuses.
- Equipped with FU5 and FU6 internal NRX 10 A fuses.
- Provides JP1, JP2, and SW1 configuration jumpers.
- Features diagnostic LED indicators for visual fuse monitoring.
TECHNICAL INFORMATION
Applications
- Gas turbine automated drive management systems.
- Steam turbine control and drive equipment.
- Wind turbine automation assemblies using DC2000 drives.
TECHNICAL INFORMATION
Installation Guidelines
- Only qualified personnel must perform maintenance on this board.
- High voltage is present within the drive and circuit board.
- Switch off the drive before removing or servicing the board.
- Remove the fuses on all three-phase power supplies.
- Disconnect the auxiliary power supply before handling.
- Wait several minutes for stored electrical power to discharge.
- Verify that no voltage remains using an electrical tester.
TECHNICAL INFORMATION
Configuration Guidelines
- Configure the JP1 jumper for MD control source selection.
- Adjust the JP2 jumper for AC contactor drop-out timing.
- Set the SW1 jumper to select AC line CT burdens.
PART VERIFICATION
Before You Order
Industrial automation parts can share similar model names, suffixes and revisions. Confirm the complete manufacturer Part Number before purchase.
01Check Part NumberMatch the complete ordering code on the existing unit.
02Confirm RevisionCheck suffix, hardware or firmware when applicable.
03Send a Label PhotoWe can review a clear label photo when identification is uncertain.
ORDERING PROCESS
From RFQ to Dispatch
1Submit Part Number2Verify Product Identity3Confirm Stock & Condition4Issue Quotation5Dispatch & Tracking
PRODUCT FAQ
Frequently Asked Questions
What is the primary role of the GE DS200SDCIG1ABA board?
The board provides DC power supply and instrumentation interfacing for DC2000 drives in Mark V systems.
How are blown fuses identified on the DS200SDCIG1ABA?
Technicians can inspect lit LED indicators on the board while power remains energized in the drive cabinet.
What safety steps must precede removal of the DS200SDCIG1ABA?
De-energize the drive, remove three-phase and auxiliary fuses, allow discharge time, and test for zero voltage.
