PRODUCT INFORMATION
Product Overview
The General Electric IS200WEORG1A is a GE Printed Circuit Board for the Mark VI / Mark VIe series. GE Energy developed this wind turbine output board specifically for Mark VIe turbine control applications. The assembly includes two Nichicon 270uF electrolytic capacitors rated for 150 degrees Celsius, designated C1 and C3. A bright orange 3kV single-layer ceramic capacitor labeled C2 is positioned next to them. Factory-printed labels are present across the board for component identification.
The circuit board incorporates fifteen total resistors across the circuit assembly. Six larger 100 Ohm resistors carry specific factory designations R1, R2, R3, R5, R8, and R9. Smaller resistors with Mexico manufacturing markings complete the remaining resistor network. Five protective fuses are visible on the board, including 250V units alongside three 600V fuses. Board silkscreening includes a power source marking indicating FROM 230L-N SOURCE 250VA MAX.
TECHNICAL DATA
Technical Specifications
| Parameter | Specification |
|---|
| PCB Coating | Normal Coating |
|---|
TECHNICAL INFORMATION
Features
- Functions as a wind turbine output board developed for GE Mark VIe control products.
- Features two Nichicon 270uF electrolytic capacitors rated for 150 degrees Celsius.
- Includes one 3kV single-layer ceramic capacitor with an orange protective coating.
- Contains fifteen total resistors, including six 100 Ohm units.
- Carries five visible fuses with ratings including 250V and 600V.
- Labeled for a 230L-N source rated up to 250VA maximum.
- Features labeled jumper positions J4 and J5.
TECHNICAL INFORMATION
Applications
- GE Mark VIe wind turbine control systems.
TECHNICAL INFORMATION
Connections / Interfaces
- Labeled jumper positions designated as J4 and J5.
- Power supply connection silkscreened FROM 230L-N SOURCE 250VA MAX.
TECHNICAL INFORMATION
Installation Guidelines
- Inspect component markings such as FA/02 LI/00 and barcode PJ2J0A9 before installation.
- Observe crimp clearances around designated resistors R1, R2, R3, R5, and R9.
- Verify fuse ratings across the onboard 250V and 600V fuse positions.
TECHNICAL INFORMATION
Configuration Guidelines
- Verify jumper positions labeled J4 and J5 prior to system installation.
TECHNICAL INFORMATION
Compatibility
- Compatible with General Electric Mark VIe turbine control systems.
COMPATIBILITY
Compatibility & Replacement
COMPATIBLE MODELSCompatible with General Electric Mark VIe turbine control systems.
Verify compatibility against the exact Part Number, revision and manufacturer documentation before ordering.
PART VERIFICATION
Before You Order
Industrial automation parts can share similar model names, suffixes and revisions. Confirm the complete manufacturer Part Number before purchase.
01Check Part NumberMatch the complete ordering code on the existing unit.
02Confirm RevisionCheck suffix, hardware or firmware when applicable.
03Send a Label PhotoWe can review a clear label photo when identification is uncertain.
ORDERING PROCESS
From RFQ to Dispatch
1Submit Part Number2Verify Product Identity3Confirm Stock & Condition4Issue Quotation5Dispatch & Tracking
PRODUCT FAQ
Frequently Asked Questions
What is the primary function of the GE IS200WEORG1A board?
The IS200WEORG1A serves as a wind turbine output board for GE Mark VIe turbine control systems.
What onboard fuses are installed on the IS200WEORG1A?
The board contains five visible fuses, including 250V rated fuses and three 600V fuses.
What capacitors are mounted on the IS200WEORG1A circuit board?
It mounts two Nichicon 270uF 150°C electrolytic capacitors and one orange 3kV ceramic capacitor.
What jumpers are present on the IS200WEORG1A board?
The circuit board contains labeled jumper positions designated J4 and J5.
